Machinery
Any quick hints on how to easily change the bearings on the side belts?
4
Yes I took off the 4 or 5 from the end i believe. And jt was enough.. I haven't done any of the drive bearings rollers just the outside roller.
step one loosen the belt a ton.. step two take off guards and sliders. i believe there is a bolt that it holds onto near the knife that has to come off so you can pull the roller towards the center than pulls out towards you.. If you have slide hammer would work best if you could get it into bearing and slide hammer it out..
1
You'd only have to remove guards and sliders right where the shafts are, correct?
Pull knife bar out end take a bunch of rock gaurds off by it and the plastic covers not too bad to do. Maybe another step or 2 involved been a while
1