Verified FBN Member (MI)

Machinery

Case 8010 sives

The sives at the rear of my 8010 are tilted even when the combine is sitting level why?

2


Verified FBN Member (SK, CAN)

Try a calibration, if not check the actuator, also check on each side of the sieve platform there are nylon wheels make sure they are good and the bearings have not gone, also in the center there is a center of the sieve holder there is a bearing at that back and front make sure they are good as well.

Join Our Community!

This comment section is reserved for FBN members only.

If you're new, please create an account to view, reply to existing comments, or add new ones.